Step by Step
Enhanced phone functions
116
CTI calls
Beep on auto-answer
Speakerphone mode activates automatically on your
phone if you use a CTI application (such as Outlook) to
dial a number when Auto Answer is active. If Auto An-
swer is not active, the phone rings first and you have to
press the loudspeaker key or lift the handset to set up
the call. This setting also defines whether or not incom-
ing calls are automatically accepted. If the function is
active, an alert beep sounds when a call is automatically
accepted. Details regarding special application are pro-
vided on  page 136.
Information on the operation of the configured CTI ap-
plication can be found in the corresponding user guide.
z
You can also configure this setting via the Web interface
 page 271.
Prerequisite: The option was programmed by your ad-
ministrator.
v Press the key shown until the "Settings" tab is active.
Confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
User
Configuration
Incoming calls
CTI calls
AutoAnswer
Yes
AutoAnswer beep
Yes
Save & exit
To Next Page
Loading...
Need help?
General