RUGGEDCOM RSG2100
Installation Guide
Chapter 4
Technical Specifications
Power Supply Specifications 29
Technical Specifications
This section details the specifications and operating conditions of the device.
CONTENTS
• Section4.1, “Power Supply Specifications”
• Section4.2, “Failsafe Relay Specifications”
• Section4.3, “Supported Networking Standards”
• Section4.4, “Copper Ethernet Port Specifications”
• Section4.5, “Fiber Optic Ethernet Port Specifications”
• Section4.6, “Operating Environment”
• Section4.7, “Mechanical Specifications”
Section4.1
Power Supply Specifications
The RUGGEDCOM RSG2100 can be equipped with the following power supplies:
CAUTION!
Electrical hazard – risk of damage to the device. Disconnect the device from the power supply if power
input is above or below the specified input range.
Hazardous Environments
Input Range
Power Supply Type
Minimum Maximum
Internal Fuse Rating
a
b
Maximum Power
Consumption
c
24 VDC 24 VDC 24 VDC 2.0 A(F)
48 VDC 48 VDC 48 VDC 1.0 A(T)
HI (125/250 VDC)
d
125 VDC 250 VDC 600 mA(T)
HI (100/240 VAC)
d
100 VAC 240 VAC 600 mA(T)
28 W
a
(F) denotes fast-acting fuse
b
(T) denotes time-delay fuse.
c
Power consumption varies based on configuration. 10/100Base-TX ports consume roughly 1 W less than fiber optic ports.
d
The HI power supply is the same power supply for both AC and DC.
To Next Page
Loading...
Need help?
General