Chapter 6
Certification
RUGGEDCOM RSG2100
Installation Guide
40 CSA/Sira
• CAN/CSA-C22.2 No. 213-M1987
Non-Incendive Electrical Equipment for Use in Class I, Division 2 Hazardous Locations
• CAN/CSA-C22.2 No. 60079-0:15
Explosive Atmospheres – Part 0: Equipment – General Requirements
• CAN/CSA-C22.2 No. 60079-15:16
Electrical Apparatus for Explosive Gas Atmospheres – Part 15: Construction, Test and Marking of Type of
Protection N Electrical Apparatus
• UL 60079-0, Edition 6.0 (2013)
Explosive Atmospheres – Part 0: Equipment – General Requirements
• UL 60079-15, Edition 4.0 (2013)
Explosive Atmospheres – Part 15: Equipment Protection by Type of Protection N
• ANSI/ISA-12.12.01-2013
Non-Incendive Electrical Equipment for Use in Class I and II, Division 2 and Class III, Division 1 and 2 Hazardous
(Classified) Locations
The device is marked with a CSA symbol that indicates compliance with both Canadian and U.S. requirements.
It is specifically approved for use in hazardous locations defined as:
• Class I, Division 2, Groups A, B, C, D T4
• Ex nA nC IIC T4 Gc
• Class I, Zone 2, AEx nA nC IIC T4 Gc
Section6.1.2
CSA/Sira
This device meets the requirements of the following CSA/Sira standards and is approved for use in hazardous
locations under certificates Sira 16ATEX4088X and IECEx CSA 16.0021X:
• 2014/34/EU (ATEX)
ATEX – Directive of the European Parliament and the Council of 26 February 2014 on the Approximation of
the Laws of the Member States Concerning Equipment and Protective Systems Intended for Use in Potentially
Explosive Atmospheres
• IEC 60079-0, Edition 6.0 (2011)/EN 60079-0:2012
Explosive Atmospheres – Part 0: Equipment – General Requirements
• IEC 60079-15, Edition 4.0 (2010)/EN 60079-15:2010
Explosive Atmospheres – Part 15: Equipment Protection by Type of Protection N
The device is marked with an ATEX marking.
To Next Page
Loading...
Need help?
General