EasyManuals Logo
Home>Siemens>Switch>RUGGEDCOM RST2228

Siemens RUGGEDCOM RST2228 User Manual

Siemens RUGGEDCOM RST2228
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Chapter 1
Introduction
RUGGEDCOM RST2228
Installation Guide
6 Gigabit Ethernet 1000Base-TX Cabling Recommendations
Section1.5.2
Gigabit Ethernet 1000Base-TX Cabling Recommendations
The IEEE 802.3ab Gigabit Ethernet standard defines 1000 Mbit/s Ethernet communications over distances of up
to 100 m (328 ft) using all 4 pairs in category 5 (or higher) balanced, unshielded twisted-pair cabling. For wiring
guidelines, system designers and integrators should refer to the Telecommunications Industry Association (TIA)
TIA/EIA-568-A wiring standard that characterizes minimum cabling performance specifications required for proper
Gigabit Ethernet operation. For reliable, error-free data communication, new and pre-existing communication
paths should be verified for TIA/EIA-568-A compliance.
The following table summarizes the relevant cabling standards:
Cabling Category
1000Base-
TX Compliant
Required Action
< 5 No New wiring infrastructure required.
5 Yes Verify TIA/EIA-568-A compliance.
5e Yes No action required. New installations should be designed with Category 5e or higher.
6 Yes No action required.
> 6 Yes Connector and wiring standards to be determined.
Follow these recommendations for copper data cabling in high electrical noise environments:
Data cable lengths should be as short as possible, preferably 3 m (10 ft) in length. Copper data cables should
not be used for inter-building communications.
Power and data cables should not be run in parallel for long distances, and should be installed in separate
conduits. Power and data cables should intersect at 90° angles when necessary to reduce inductive coupling.
Shielded/screened cabling can be used when required. Care should be taken to avoid the creation of ground
loops with shielded cabling.
Section1.5.3
Supported Fiber Optic Cables
The following fiber optic cable types are supported under the stated conditions.
Distance (m)
Cable Type Wavelength (nm)
Modal Bandwidth
(MHz·km)
100Base-FX 1000Base-SX 10GBase-SR
850 200 275 33OM1 (62.5/125)
1300 500 2000
850 500 550 82OM2 (50/125)
1300 500 2000
850 1500 550 300OM3 (50/125)
a
1300 500 2000
850 3500 550 400OM4 (50/125)
a
1300 500 2000
a
Laser optimized.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens RUGGEDCOM RST2228 and is the answer not in the manual?

Siemens RUGGEDCOM RST2228 Specifications

General IconGeneral
BrandSiemens
ModelRUGGEDCOM RST2228
CategorySwitch
LanguageEnglish

Related product manuals