Chapter 2
Installing the Device
RUGGEDCOM RST2228
Installation Guide
8 Unpacking the Device
IMPORTANT!
The user is responsible for the operating environment of the device, including maintaining the integrity
of all protective conductor connections and checking equipment ratings. Make sure to review all
operating and installation instructions before commissioning or performing maintenance on the
device.
1. Review the relevant certification information for any regulatory requirements.
For more information, refer to Section6.1, “Approvals”.
2. Review the RUGGEDCOM RST2228 Modules Catalog for special installation or regulatory requirements
related to the modules installed in the device.
For more information, refer to “Related Documents”.
3. Unpack and inspect the device.
For more information, refer to Section2.2, “Unpacking the Device”.
4. Mount the device.
For more information, refer to Section2.3, “Mounting the Device”.
5. Connect the failsafe alarm relay.
For more information, refer to Section2.4, “Connecting the Failsafe Alarm Relay”.
6. Connect power to the device and ground the device to safety Earth.
For more information, refer to Section2.5, “Connecting Power”.
7. Connect the device to the network.
For more information, refer to Chapter4, Communication Ports.
8. Configure the device.
For more information, refer to Section3.2, “Configuring the Device”.
Section2.2
Unpacking the Device
When unpacking the device, do the following:
1. Inspect the package for damage before opening it.
2. Visually inspect each item in the package for any physical damage.
3. Verify all items are included.
IMPORTANT!
If any item is missing or damaged, contact Siemens for assistance.
Section2.3
Mounting the Device
The RUGGEDCOM RST2228 is designed for maximum mounting and display flexibility. It can be ordered with
adapters that allow it to be installed in a 48 cm (19 in) rack or directly on a panel.
To Next Page
Loading...
Need help?
General