Chapter 5
Technical Specifications
RUGGEDCOM RX1501
Installation Guide
40 Failsafe Relay Specifications
Section5.2
Failsafe Relay Specifications
Maximum Switching Voltage Rated Switching Current Isolation
30 VDC 5 A
125 VDC 0.1 A
c
, 0.15 A
d
250 VAC 6.25 A
2800 VDC for 1 minute
between coil and contacts
c
Inductive load R/L = 7 ms
d
Resistive load
Section5.3
Operating Environment
The RUGGEDCOM RX1501 is rated to operate under the following environmental conditions.
IMPORTANT!
Temperature limits for select line modules may differ from that which can be withstood by the
RUGGEDCOM RX1501. Make sure the selected modules are rated for the expected environmental
conditions before deployment. For more information, refer to the RUGGEDCOM RX1501 Series Modules
Catalog.
Ambient Operating Temperature
efg
-40 to 85 °C (-40 to 185 °F)
Ambient Storage Temperature -40 to 85 °C (-40 to 185 °F)
Ambient Relative Humidity
h
5% to 95%
Maximum Altitude 12192 m (40000 ft)
e
Maximum ambient operating temperature is 70 °C (158 °F) when the device is installed along with Underwriter Laboratories (UL) listed devices.
f
Measured from a 30 cm (12 in) radius surrounding the center of the enclosure.
g
Operating temperature may vary based on the limitations of installed SFPs. Refer to the RUGGEDCOM SFP Transceivers Catalog for SFP temperature ratings.
h
Non-condensing.
Section5.4
Mechanical Specifications
Weight Approximately 4.7 kg (10.3 lb)
Ingress Protection IP30
Enclosure Aluminum
To Next Page
Loading...
Need help?
General