Siemens RUGGEDCOM RX1501 Installation Guide

Chapter 4
Modules
RUGGEDCOM RX1501
Installation Guide
36 Installing/Removing Power Modules
Section4.3
Installing/Removing Power Modules
The RUGGEDCOM RX1501 supports a single power module.
1
Figure23: Power Module
1.Power Module
CAUTION!
Contamination hazard – risk of equipment damage. Prevent the ingress of water, dirts and other debris
that may lead to premature equipment failure. Always make sure slots are not left empty.
Removing a Power Module
To remove a power module, do the following:
DANGER!
Electrocution hazard – risk of serious personal injury or death. Make sure power to the module is
turned off before servicing the power supply terminal.
1. Turn off power to the module.
2. Loosen the screws that secure the module to the chassis until the module can be removed.
3
2
1
Figure24:Removing a Power Supply
1.Chassis 2.Power Supply 3.Screws
3. Slide the module out of the chassis.

Siemens RUGGEDCOM RX1501 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RX1501
Category	Switch
Language	English