Installation
3.2 Mounting on DIN rails
SCALANCE XB-200
Operating Instructions, 09/2015, C79000-G8976-C359-03
21
Figure 3-1 DIN rail mounting
To install the device on a 35 mm DIN rail complying with DIN EN 60715, follow the steps
below:
1. Place the housing guide of the device on the top edge of the DIN rail
①.
2. Press the device down against the DIN rail until the spring catch locks in place
②.
3. Fit the connectors for the power supply, see the section "Power supply (Page 25)".
4. Insert the terminal blocks into the sockets on the device.
To Next Page
Loading...
Need help?
General
