Mounting and connecting
3.4 Switching on and testing the HMI device
Basic Panels
Operating Instructions, 04/2012, A5E02421799-03
49
The Loader opens after the operating system has started.
● Touch devices: You operate the loader via the buttons on the touch screen
● Key devices: You use the cursor keys to operate the loader menu. You use the
<ENTER> key to execute a menu command or switch to a submenu.
<Loader version>
Transfer
Start
Info/Settings
• Press the "Transfer" button or use the "Transfer"
menu command to set the HMI device to "Transfer"
mode.
The transfer mode can only be activated when at
least one data channel has been enabled for the
transfer.
• Press the "Start" button or use the "Start" menu
command to start the project on the HMI device.
If you do not perform an operation, the project on the
HMI device will automatically start after a delay.
• Press the "Control Panel" button or use the
"Info/Settings" menu command to open the Control
Panel of the HMI device.
You can change various settings in the Control Panel,
for example, the transfer settings.
Shutting down the HMI Device
1. Close any active projects on the HMI device.
2. Shut down the HMI device. You have the following shutdown options:
– Switch off the power supply.
– Remove the power supply terminal from the HMI device.
To Next Page
Loading...
Need help?
General
