Parameterizing the Mobile Panel
5.13 Configuring network operation
Mobile Panels 2nd Generation
134 Operating Instructions, 09/2018, A5E33876626-AC
5.13.5 Configuring e-mail
You use this function to set the SMTP server, sender name and e-mail account for e-mail
service.
Requirement
● The Control Panel is open.
● Your system administrator has provided you with the necessary information.
Note
Additional tabs may appear in the "WinCC
Internet Settings" dialog. This depends on the
options that have been enabled for operating the loc
al network in the project.
Procedure
1. Open the "WinCC Internet Settings" dialog using the "WinCC Internet Settings" icon.
2. Change to the "Email" tab.
Setting of the SMTP server
Name of the sender and e-mail account
"Advanced" button for additional settings
3. Specify the SMTP server.
– Select the "Use the default of …" option if you want to use the SMTP server
configured in the project.
–
Clear the "Use the default of …" option if you do not want to use the SMTP server
configured in the project. Enter the required SMTP server and the corresponding port.
4. Enter the name of the sender in the "Name of sender" entry field.
The computer name is an appropriate sender name – see section
"Specifying the computer name of the HMI device (Page 131)".
5. Enter the e-mail account you use to send your e-mail in the "eMail address of sender"
entry field.
The "eMail address of sender" entry field can remain empty if your e-mail provider allows
e-mails to be sent without checking the e-mail account.
To Next Page
Loading...
Need help?
General
