Siemens SIMATIC HMI OP 73micro User Manual

Operating a project
8.1 Operating a project on OP 73micro
OP 73micro, TP 177micro (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
111
Procedure
Proceed as follows:
1. Enable the selection list with
ENTER
.
This enables the selection list which contains the configured symbolic entries.
2. Select an entry with
TAB
or
+/–
.
3. Save or cancel the entry.
8.1.3.4 Entering and modifying date and time
Requirements
A date/time input field has been enabled with
SHIFT
+
TAB
or using the cursor keys.
Entering the date and time
Use numerical and alphanumerical values to set the date and time.
Note
When entering the date and time, please note that the format is determined by the
configured project language.
See also
Entering and Editing Numerical and Alphanumerical Values (Page 107)
Setting the project language (Page 105)

Siemens SIMATIC HMI OP 73micro Specifications

General

Brand	Siemens
Model	SIMATIC HMI OP 73micro
Category	Control Panel
Language	English