Siemens SIMATIC HMI OP 73micro User Manual

OP 73micro, TP 177micro (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
71
Configuring the operating system
6
6.1 Configuring the operating system for the OP 73micro
6.1.1 Overview
Loader
The figure below shows the Loader. It appears briefly when the HMI device starts up.
Loader
Start
Transfer
Info/Settings
Figure 6-1 Loader
The Loader menu commands have the following functions:
● "Transfer"
Select this menu command to set the HMI device transfer mode.
● "Start"
Select this menu command to start the project which is stored on the HMI device.
● "Info/Settings"
Select this menu command to open the HMI device configuration menu.
The Loader also appears when you close the project.
Navigating in the Loader
Button Action
+/–
or
TAB
By pressing one of these buttons, you select the next menu command
in the direction of the cursor key.
ENTER
The corresponding menu opens.
ESC
HELP
Returns to the next higher menu layer.

Siemens SIMATIC HMI OP 73micro Specifications

General

Brand	Siemens
Model	SIMATIC HMI OP 73micro
Category	Control Panel
Language	English