Siemens SIMATIC HMI OP 73micro User Manual

Preparing and backing up a project
7.2 Transfer
OP 73micro, TP 177micro (WinCC flexible)
92 Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
7.1.3 Data Transfer Options
Overview
The following table shows the options for transferring data between the configuration
computer and OP 73micro or TP 177micro.
Type Type OP 73micro TP 177micro
Serial (with reset to factory setting) No No Backup
Serial Yes Yes
Serial (with reset to factory setting) Yes
1)
/ No
2)
Yes
1)
/ No
2)
Restore
Serial No
1)
/ Yes
2)
No
1)
/ Yes
2)
Serial (with reset to factory setting) Yes Yes Updating the operating
system
Serial No No
Serial (with reset to factory setting) No No Transfer of a project
Serial Yes Yes
1)
Applies to complete restore
2)
Applies to restoring the password list
Serial transmission
You can use one of the following adapters for the serial transmission to the configuration PC:
● RS 232/PPI cable MM Multimaster
● USB/PPI cable MM Multimaster (as of manufacturer version 05 of the cable)
7.2 Transfer
7.2.1 Overview
Transfer
During transfer, the project is downloaded from the configuration computer to the HMI
device.
"Transfer" mode can be started on the HMI device.
Transferred data is written directly to the flash memory on the HMI device. The data channel
must be configured before you start the transfer.

Siemens SIMATIC HMI OP 73micro Specifications

General

Brand	Siemens
Model	SIMATIC HMI OP 73micro
Category	Control Panel
Language	English