3.3 SELECT / SET button
Position
The "SELECT/SET" button is located on the front of the device.
Figure 3-1 Position of the "SELECT/SET" button, for example on the SCALANCE XC-200 with 8 ports
Setting the display mode
To set the required display mode, press the "SELECT/SET" button.
For more detailed information on the display modes, refer to the section "LEDs "DM1" and
"DM2" (Page 31)".
Resetting the device to factory defaults
NOTICE
Previous settings
If you reset, all the settings you have made will be overwritten by factory defaults.
NOTICE
Inadvertent reset
An inadvertent reset can cause disturbances and failures in the configured network.
Description of the device
3.3 SELECT / SET button
SCALANCE XC-200
Operating Instructions, 12/2017, C79000-G8976-C442-03 27
To Next Page
Loading...
Need help?
General