01.02 2 Glossary / Abbreviations
© Siemens AG 2002 All Rights Reserved 6FC5598-3AA20-0BP2
SINUMERIK 802S/802C (DG) 2-109
Program Test
Random Access Memory
Reduced Instruction Set Computer
Rapid Override
R Parameters Active (NCK memory area for R parameter numbers)
Request To Send (control signal from serial data interfaces)
Single Block
Single Block Decoding
Setting Data Active (memory area for setting data in NCK)
Setting Data
Skip Block
Signal Module
Sub Program File
Programmable Logic Controller
Cutter Radius Compensation
Leadscrew Error Compensation
Serial Synchronous Interface
Software
Testing Data Active (with reference to the machine data)
PRT
RAM
RISC
ROV
RPA
RTS
SBL
SBL2
SEA
SD
SKP
SM
SPF
SPS
SRK
SSFK
SSI
SW
TEA
To Next Page
Loading...
Need help?
General
