Siemens SINUMERIK 802C Diagnostics Guide

01.02 1 Alarms
© Siemens AG 2002 All Rights Reserved 6FC5598-3AA20-0BP2
SINUMERIK 802S/802C (DG) 1-93
1.3 PLC Alarms
PLC Stop [type]
PLC is not in cyclic operation. Traversing with machine is not possible.
Type: 1 Ready (user program has not been started)
2 Break (user program has been interrupted)
3 Error (further PLC alarm with PLC Stop exists)
Alarm display
Eliminate other PLC alarm;
set start-up switch to a position other than 4,
or test user program.
POWER ON
Select Start-Up menu to continue
Start via PT 802 Programming Tool
System error [type]
%1 = Type number
This alarm refers you to internal error states that in conjunction with the error
number displayed provide you with information on error cause and error loca-
tion.
PLC stop
Please report this error with type number to Siemens.
For error cause refer to the specified software section in the displayed line
number
POWER ON
Connection to op. panel faulty
A fault in the connection between operator panel and PLC has been detected
during cyclic operation.
Emergency Stop
Check cable connection to operator panel or replace operator panel.
Press CLEAR to clear the alarm.
Code error: Network [No.] [string]
[ No. ] = Network number
[ string ] = internal error code
The user program contains an operation which is not supported by the control
system.
PLC stop
400 000
Explanation
Response
Remedy
Program continua-
tion by
400 002
Explanation
Response
Remedy
Program continua-
tion by
400 003
Explanation
Response
Remedy
Program continua-
tion by
400 004
Explanation
Response

Siemens SINUMERIK 802C Specifications

General

Brand	Siemens
Model	SINUMERIK 802C
Category	Control Systems
Language	English