11.90 3 Operating Sequences
3.1.15 Data input/data output
or or
1
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
F
2
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
D
0
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
S
Start the output of the R parameters by operating the
”START” softkey.
In the same way, you can select and start the output of data for the following:
– ”TOOL OFFSET”
– ”ZERO OFFSET”
– ”MACHINE DATA”
– ”PLC MACHINE DATA”
which have not been detailed here.
START
Using this softkey, you can stop data output at any time...
and continue it again with ”START”.
STOP
ETX
START
You can use the ”ETX START” softkey to output the end
of transmission character stored in setting data.
This is always output irrespective of whether RTS-line or
X on/off protocol is set.
• • •
Using the keyboard, enter the
channel no.:
into the input field marked in
inverse video:
”1” for output of local
R parameters, channel 1
”2” for output of local
R parameters, channel 2
”0” for output of the global
R parameters
a
a
a
a
a
a
a
a
a
a
Note:
• A selection of the data, ie. the output of a section as with ”PART PROGRAM”, is not possible!
• The input of a channel no, is only required by the control for ”R PARAMETERS”.
• Data output with or without leader or trailer can be set via setting data (SD 5016, bit 1).
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EQ02
3-87
SINUMERIK 810M, GA3 (BN)
To Next Page
Loading...
Need help?
General
