Siemens SINUMERIK 810M User Manual

09.91 2 Operation
2.3.5 Branching to operating functions within an operating mode
2.3.5.2 Example for the selection of further operating functions within
the same menu
To call further operating functions in the control in the same menu,
The menu on the CRT can display max. 5 functions.
((Foto - Nr. 810M/14 einmontieren))
Basic CRT display in
”AUTOMATIC” mode.
First menu of 5 functions.
Basic CRT display in
”AUTOMATIC” mode.
Menu extension with 5
functions.
Operate the ETC key on the
right, below the CRT.
you use the ETC key:
Example:
((Foto - Nr. 810M/13 einmontieren))
2.3.5.3 Menu display from the NC program or from the PLC
The control allows you to display any menu from the system or user area at any time. This is
done either via a new interface (DB 40) in the PLC program or a new softkey function
(SK 56). The machine tool manufacturer defines which menus can be displayed when.
For further details see the relevant User's Guide of the machine tool manufacturer.
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EQ02 2-45
SINUMERIK 810M, GA3 (BN)

Siemens SINUMERIK 810M Specifications

General

Brand	Siemens
Model	SINUMERIK 810M
Category	Control Systems
Language	English