SDB 2400 F4
■ 36
│
GB
│
MT
Plugging in and ironing
Dry ironing without steam is possible at all temperatures, steam ironing is only
possible from the setting range
on the temperature control 8.
1) Insert the plug into a mains power socket.
CAUTION – PROPERTY DAMAGE!
► If the clothing care instructions forbid ironing (
), the garment must not
be ironed. Ignoring this warning could lead to permanent damage to the
clothing item.
2) Check the care instructions on the labels in garments to see if they are suitable
for being ironed, and at which temperature setting.
Temperature control
symbol 8
Material type
Synthetics
Silk, wool
Cotton, linen
3) Select the appropriate temperature setting with the temperature control 8.
NOTE
► Always place the iron on the base 0 while it heats up. If you place the
iron on the sole of the iron q and do not move it, the automatic switch-off
will be activated after 30 seconds (see section Automatic switch-off)
and the appliance stops heating up.
■ The temperature control lamp 7 lights up. When the set temperature has been
reached, the temperature control lamp 7 goes out.
4) Wait until the temperature control lamp 7 goes out.
■ To moisten the laundry, press the spray button
5.
■ This function is suitable for very dry and very crumpled garments.
Steam ironing
1) Set the steam control 3 to the desired steam setting.
2) The temperature control 8 must be set to at least the
setting.
Otherwise no steam will be produced.
To Next Page
Loading...
Need help?
General
