EasyManuals Logo
Home>Silvercrest>Iron>SDB 2400 F4

Silvercrest SDB 2400 F4 User Manual

Silvercrest SDB 2400 F4
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
SDB 2400 F4
38 
GB
MT
Automatic switch-off
This steam iron is fitted with an automatic switch-off system. This stops the iron
from heating up.
If the iron is resting on the sole of the iron q and is not moved for about
30 seconds, you will hear a warning beep and the control lamp for the
automatic switch-off 6 will flash. The iron will stop heating up. To deactivate
the automatic switch-off, lift up the iron and move it gently from side to side. The
control lamp for the automatic switch-off 6 goes out and the iron will heat up
again.
If the iron is on its base 0 and is not moved for about 8 minutes, there will be a
warning beep and the control lamp for the automatic switch-off 6 flashes. The iron
will stop heating up. To deactivate the automatic switch-off, lift up the iron and
move it gently from side to side. The control lamp for the automatic switch-off 6
goes out and the iron will heat up again.
NOTE
The automatic switch-off is not intended as a substitute for removing the
plug from the mains power! This is merely intended to reduce the fire hazard
if you forget to switch off the iron!
Cleaning
Self-cleaning function
1) Fill the water tank to the "MAX" marking.
2) Insert the plug into the mains power socket.
3) Move the temperature control 8 to the "MAX" position.
4) Set the steam control 3 to maximum steam power.
5) Allow the steam iron to heat up until the temperature control lamp 7 goes out
and then lights up again.
6) Hold the steam iron horizontally over a suitable container.
7) Press the self-clean button w and keep it pressed. Move the steam iron back
and forth a little. Steam and boiling water will flow from the steam exit holes in
the sole of the iron q. Any impurities that may be present are flushed out.
8) Release the self-clean button w as soon as all of the water in the water tank is
used up.
9) Dry the sole of the iron q thoroughly. To do this, move the sole of the iron q
back and forth several times over a towel or an old piece of material.
10) Allow the steam iron to cool down before placing it in storage.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest SDB 2400 F4 and is the answer not in the manual?

Silvercrest SDB 2400 F4 Specifications

General IconGeneral
BrandSilvercrest
ModelSDB 2400 F4
CategoryIron
LanguageEnglish

Related product manuals