Silvercrest SDBK 2400 F5 User Manual

22
GB
7. Operation
DANGER!
~ The sole plate20 becomes very hot
during operation. During operation
touch only the handle6 and the control
elements of the steam iron.
~ Even during short interruptions, always
place the steam iron in the stand7 and
never on its sole plate20. There is a
fire hazard!
NOTE: You may notice an odour when us-
ing for the first time. This is a result of the
manufacturing process and is not a defect
with the device. Ensure adequate ventila-
tion.
The sole plate20 cools down slightly during
ironing. In order to reach the set temperature
again, the device heats the sole plate20 up
again, during which the temperature control
lamp14 is lit. The temperature control
lamp14 goes out again when the set tem-
perature is reached. This process repeats it-
self during ironing.
Ironing with cable: simply continue iron-
ing during the heating phase.
If you wish to shorten the power cable some-
what, press it into the cable clamp22 at the
desired point.
Cable-free ironing: the steam iron stands
on the stand7.
Wait until the temperature control lamp14
goes out. For purposes of heating up, regu-
larly place the steam iron on the stand7.
7.1 Filling the water tank
DANGER!
~ Pull the mains plug9 out of the socket
before you fill up the water tank15.
•Use clean tap water without any addi-
tives (e.g. vinegar, limescale remover,
starch, perfume, softener).
•The integrated anti-limescale protection
reduces limescale deposits for average
water hardness, and thus extends the
service life of the device. If your tap wa-
ter is hard, use distilled water. Where
the water is moderately hard, mix dis-
tilled water and tap water at a ratio of
1:1.
1. Disconnect the mains plug9 from the
wall socket.
2. Set the steam flow rate controller3 to
.
3. The switch11 is in the position . Re-
move the steam iron from the stand7.
4. Open the lid2 (of the water tank) and
tilt the iron forwards slightly to fill it.
5. Use the measuring beaker21 to pour in
water up to the mark19 max, but at
least up to one quarter. Hold the steam
iron upright to check.
6. Close the lid2 (of the water tank).
7. Place the steam iron on the stand7 and
set the steam flow rate controller3 to
the desired position.
__317392_Dampfbuegeleisen_B8.book Seite 22 Donnerstag, 20. Juni 2019 1:08 13

Silvercrest SDBK 2400 F5 Specifications

General

Brand	Silvercrest
Model	SDBK 2400 F5
Category	Iron
Language	English