Silvercrest SDBK 2400 F5 User Manual

23
GB
7.2 Set iron temperature
NOTE: The steam iron must be connected to
the stand7 in order to heat up.
1. Figure C: Set the desired temperature
using the temperature controller17:
- MIN the device is not getting hot
-
÷ temperature: up to
approx. 110 °C
(synthetic materials)
-
÷÷ temperature: up to
approx. 150 °C
(Silk, wool)
-
÷÷÷ temperature: up to
approx. 210 °C
(linen, cotton)
- MAX maximum temperature
2. The temperature control lamp14 is lit
for as long as the steam iron is heating.
It goes out when the set temperature has
been reached. You can then begin iron-
ing.
7.3 Spray function
Use the spray function in order to dampen
dry items of laundry. This option is available
irrespective of the set temperature. For this
purpose, the water tank15 must be at least
one quarter full.
•Repeatedly press the spray button5 .
While doing so, hold the steam iron
horizontally with the tip over the item of
laundry. Ensure that no water sprays
onto the ground.
7.4 Ironing without steam
Sensitive fabrics are ironed at lower temper-
atures and without steam. In order to damp-
en them, the spray function is available.
1. Set the steam flow rate control3 to
and set the temperature controller17 to
MIN.
2. Fill the water tank15 if you wish to use
the spray function.
3. Place the steam iron in the stand7.
4. Connect the mains plug9 with the wall
socket.
5. Set the desired temperature using the
temperature controller17. The tempera-
ture control lamp14 lights up.
6. Start ironing as soon as the ironing tem-
perature has been reached and the tem-
perature control lamp14 goes out.
7. Finish ironing, set the temperature con-
troller17 to MIN and pull out the
mains plug9.
8. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank15 through the filling open-
ing in the water tank (under the lid2).
7.5 Ironing with steam
Steam ironing requires a high temperature,
at least the temperature setting for . In or-
der to additionally dampen items of cloth-
ing, the spray function is also available.
1. Set the steam flow rate control3 to
and set the temperature controller17 to
MIN.
2. Fill the water tank15.
3. Place the steam iron in the stand7.
4. Connect the mains plug9 with the wall
socket.
5. Set the temperature controller17 to the
desired temperature (at least ). The
temperature control lamp14 lights up.
6. As soon as the ironing temperature has
been reached and the temperature con-
trol lamp14 goes out, adjust the steam
__317392_Dampfbuegeleisen_B8.book Seite 23 Donnerstag, 20. Juni 2019 1:08 13

Silvercrest SDBK 2400 F5 Specifications

General

Brand	Silvercrest
Model	SDBK 2400 F5
Category	Iron
Language	English