Silvercrest SDBK 2400 F5 User Manual

24
GB
flow rate controller3 to the desired
steam flow rate and start ironing.
The steam will ...
… start to come out as soon as you hold
the steam iron horizontal, and
…stop as soon as:
- you hold the steam iron vertically,
- you place the steam iron into the
stand7,
-the temperature is too low,
- the water tank15 is empty
or
-you set the steam flow rate control-
ler3 to .
7. Finish ironing, set the temperature con-
troller17 to MIN, set the steam flow
rate controller3 to and pull out the
mains plug9.
8. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank15 through the filling open-
ing in the water tank (under the lid2).
7.6 Steam jet function
The steam jet function requires a high tem-
perature. Select a temperature setting be-
tween and MAX. For this purpose, the
water tank15 must be at least one quarter
full. The steam flow rate controller3 is locat-
ed to the left on the symbol .
• Press the steam jet button while the
steam iron glides over the item of laun-
dry4 .
•Wait a few seconds before you press
the steam jet button4 again.
NOTE: For smoothing items of clothing that
are hanging up, you can use the steam jet
Button in a vertical position.
8. Cleaning
DANGER!
~ Pull the mains plug9 out of the wall
socket before you clean the steam iron.
~ Allow the device to cool down before
cleaning.
CAUTION:
~ Do not use any astringent or abrasive
cleaning agents.
Cleaning the device
•For cleaning the device, use a soft,
moistened cloth.
•Dirt can be removed from the sole
plate20 using commercially available
cleaning agents for chrome, silver or
stainless steel.
•Residues that have melted on can be re-
moved by heating the steam iron up to
the MAX setting and then ironing an
old cotton cloth.
Self-cleaning
CAUTION:
~ Do not put vinegar, limescale remover
or any other additives into the water
tank15. Additives can damage the de-
vice.
If you use tap water, you should run the self-
cleaning cycle after every use. Otherwise
use the self-cleaning cycle at least twice per
month.
1. Fill the water tank15.
2. Place the steam iron in the stand7.
3. Connect the mains plug9 with the wall
socket.
4. Set the steam flow rate controller3 to
and set the temperature control-
ler17 to MAX.
__317392_Dampfbuegeleisen_B8.book Seite 24 Donnerstag, 20. Juni 2019 1:08 13

Silvercrest SDBK 2400 F5 Specifications

General

Brand	Silvercrest
Model	SDBK 2400 F5
Category	Iron
Language	English