Silvercrest SLR 30 A1 User Manual

GB
│
CY
│

11 ■
SLR 30 A1
Timer function
You can use the timer function to set the operating time of the appliance to be-
tween 1, 2, 4 or 8 hours. After the set operating time has elapsed, the appliance
turns off automatically and switches to standby mode. To set the timer function,
proceed as follows:
Ƈ During operation, briefly press the timer button
2 once to activate the timer
function. Then press the timer button 2 briefly, several times if necessary, to
set the required operating time (1 hr, 2 hrs, 4 hrs, 8 hrs). The set operating time
is displayed on the control panel 1 and the timer button 2 lights up.
Ƈ To deactivate the timer function, press the timer button
2 briefly several times
(if necessary) during operation until the operating time display (1 hr, 2 hrs,
4hrs, 8 hrs) goes out and the timer button 2 is no longer illuminated.
NOTE
► When the appliance is switched off, the last selected settings of all
functions are saved. These are then used when the appliance is switched
on again. If you disconnect the appliance from the power supply, the last
selected settings are deleted.
Cleaning and maintenance
Cleaning the appliance
RISK OF ELECTRICAL SHOCK!
► Switch the appliance off and pull out the mains plug before cleaning the
appliance!
ATTENTION! PROPERTY DAMAGE
► Do not use caustic, abrasive or solvent-based cleaning materials. These can
damage the surfaces of the appliance.
Ƈ Clean the appliance with a dry or slightly moist cloth. For stubborn soiling, use
a little mild detergent on the dampened cloth.
Ƈ Clean the ventilation openings carefully and regularly with a suitable soft brush
to remove dust and dirt.

Silvercrest SLR 30 A1 Specifications

General

Brand	Silvercrest
Model	SLR 30 A1
Category	Air Cleaner
Language	English