Regent / 500 / 2500 / LT Series
1/2006 3 TP 300-4218-04-RG-SMAN
Quick Setup List
Page Setup Procedure Steps to Perform
4 Uncrating
o Remove Crate & Banding.
o Place Transmission Release Lever in PUSH position & Roll
Tractor forward off skid.
4 Battery Charging & o Charge the Battery
(Note: proceed with other setup steps
Installation
while battery is charging).
o Install Battery.
5 Check Fluid Levels o Check Transmission fluid level.
o Fill & check Engine oil level.
6 SAFETY CHECKS o Check for LOOSE HARDWARE.
o Check all OPERATOR CONTROLS.
o Test PARKING BRAKE.
o Perform MOWER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)
o Check the Seat Switch connection.
o Perform SAFETY INTERLOCK SYSTEM CHECK.
7 Torque Mower Blades o Torque mower blades.
7 Burnish Electric Clutch o Burnish Electric Clutch
(run for 15 seconds, repeat 10
times)
.
7 Reduce &
Check Tire Pressure
o Reduce & check Tire Pressure.
(Front Tires 12-15 psi, Rear tires 10-12 psi)
8 Lubrication o Lubricate all grease & oil points.
10 Mower Assembly o Install Mower Deck onto Tractor and Attach Belt
(select models).
o Level Mower Deck (Side-to-side & Front-to-back).
14 Adjustment Procedures o Gauge Wheels (select models).
To Next Page
Loading...
Need help?
General
