User Manual of A90 Series Inverter
229
to F14.34 correspond to F01.00 to F01.34, which are motor nameplate parameters, motor
parameters and encoder parameters; the function code F14.35 corresponds to F00.01, which
is used to select the motor drive mode; the function codes F14.36 to F14.76 correspond to
F06.00 to F06.40, which are vector control parameters; and the function code F14.77 is
used to select the acceleration/deceleration time of the motor 2. Only the parameters of
F14.72 are described below. For the rest of the parameters, refer to the relevant parameters
of the motor 1.
Acceleration/decelerati
on time options of
motor 2
0: the same as motor 1
1: acceleration and
deceleration time 1
2: acceleration and
deceleration time 2
3: acceleration and
deceleration time 3
4: acceleration and
deceleration time 4
F14.77=0
: the acceleration/deceleration time of the motor 2 is the same as that of the
motor 1. For details, see the description of the function codes F15.03 to F15.09;
F14.77=1/2/3/4
: the acceleration/deceleration time of the motor 2 is fixed as the
acceleration/deceleration time 1/2/3/4, corresponding to the function codes F00.14,
F00.15/F15.03, F15.04/F15.05, F15.06/F15.07 and F15.08, respectively.
7.16 Auxiliary Function Parameter Group of F15 Group
0.00 to maximum
frequency F00.16
0.00 - 650.00 (F15.13=0)
0.0 - 6500.0 (F15.13=1)
0 - 65000 (F15.13=2)
0.00 - 650.00 (F15.13=0)
0.0 - 6500.0 (F15.13=1)
To Next Page
Loading...
Need help?
General