User Manual of A90 Series Inverter
63
Chapter 6 Function Code Table
6.1 Description of Function Code Table
The function codes of the A90 series inverter (hereinafter referred to as the “function
codes”) are divided into 24 groups in Table 6-1, and each group contains several function
codes. Among them, the F18 group is a monitoring parameter group used to view the
inverter status; the F19 group is a fault record group used to view the details of the last
three faults; and other groups are parameter setting groups to meet different functional
requirements.
Table 6-1 Introduction to Function Code Groups
★
Some parameters of the current series are reserved, and their readings are 0. Some
options of parameters are reserved and settable, but this may result in abnormal
operation of the inverter. Please avoid misuse of such parameters.
Basic function parameter
group
Parameter group of motor
1
Input terminal function
group
Output terminal function
group
Start/stop control
parameter group
V/F control parameter
group
Vector control parameter
group
Protection function setting
group
Multi-segment speed and
simple PLC
Communication function
group
User-selected parameter
group
Keyboard and display
function group
Torque control parameter
group
Parameter group of motor
2
Customization function
group
Virtual I/O function group
Monitoring parameter
group
To Next Page
Loading...
Need help?
General