Safety Instructions
1.1
Important
Instructions
sure all relevant safety specifica-
tions are adequate to specifica-
tions and technical standards in
your country.
The machine should not be run
without its safety devices.
For your safety, goggles must be
used while running the machine.
Turn off or unplug the machine
when the followingsituationsarise:
Passing the thread by the nee-
dle or replacing the bobbin or
looper.
Replacing the needle, presser
foot, throat plate, feed dog and
sliding plate.
When the machine is in mainte-
nance.
When the operator is not run-
ning the machine.
with the eyes or skin, washed the
surface with plenty oficy water
withagenerous amount of cold
water. In case ofingestion, seek
medical help immediately.
should only be performed by
properly trained personnel.
Maintenance and repair on elec-
tric equipment should only be
made by qualified personnel. If
any electric device is damaged,
the machine should be immedi-
ately stopped.
Before starting the machine in full
running,atest
must be conducted
to assure that machine and opera-
tor are able to perform the task.
The machine should not be placed
next toasound source as an ultra-
sonic welding machine and other
equipment.
The machine should only be run
with the proper electric cable and
connectors, and also the adequate
grounding.
The machine should only be used
to sew materials as indicated in
its instructions manual, and indi-
cations of use should be followed.
Singer will not be held responsible
for any damage caused by unau-
thorized changes in the product.
When using the
machine, basic safety
procedures must
with attention all
instructions before
using the machine.
When using it,
understand that
all basic safety
instructions are
not limited to the
following items.
Read all instructions,
take care of this
manual, and use it
as reference when
necessary.
Safety
be followed. Read
Before running the machine, make
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
1
|
Instruction Manual and Parts List
·
Please don’t operate when envi-
ronment temperature is above
45°C or below 0°C.
Avoid operating in the area where
humidity is 30% less and 95% more,
also keep away from dew or acid
spray area.
Integrated Energy Saving Direct Drive Motor Lockstitch Sewing Machine