Singer C440 User Manual

17
SETTING UP THE MACHINE
PREPARING THE BOBBIN
Be sure to use only SINGER
®
Class 15 bobbins (transparent)
in this machine.
1. Pull the bobbin cover latch to the right and remove the
bobbin cover.
2. Lift up the bobbin from the machine.
ThreadingtheMachine
SettingSpoolofThreadonSpoolPin
See page 19.
BobbinWinding
1. Hold thread in both hands and hook thread to the guide
from front opening.
2. Bring thread to the right and pass it through the thread
guide from the back side. Pass thread under the bobbin
winding tension disk in a clockwise direction, making sure
it is placed snuggly under the disk.
3. Insert thread through hole in bobbin and place the bobbin
on bobbin winder spindle.
4. Hold the end of the thread and push bobbin stopper to the
right. When the bobbin winding screen appears, press the
start/stop button on the screen to start winding.
5. After the bobbin winds a few turns, stop the machine by
pressing the start/stop button on the screen.
6. Cut the thread next to the hole on top of the bobbin. None
of the thread end should be left showing above the hole.
7. Start the machine again by pressing the start/stop button
on screen. You can adjust winding speed by pressing “+”
(faster) or “-” (slower) button on the screen.
8. When the bobbin is wound fully, the bobbin stopper will
return to the left and stop winding automatically.
9. Remove the bobbin from the spindle and cut thread with
the thread cutter.

Singer C440 Specifications

General

Brand	Singer
Model	C440
Category	Sewing Machine
Language	English