Class 99 & 99K
THE BINDER
The binder is used to apply commercial
binding as well as self-fabric bias to an
unfinished edge.
This colorful trim is attractive when
applied to children's wear, aprons and
fabric furnishings. It is a practical finish
for seam edges that ravel and for
making bound seams.
Inserting the Binding
Pre-folded commercial bias binding is
inserted from the right into the outside
slot of the binder scroll.
Cut the binding diagonally to form
a long point.
●
Insert the pointed end into the slot
and pull through the scroll until
the evenly folded edges are
under the needle. Self-fabric bias
binding should be cut 15/16" wide
on the true bias.
●
Insert the unfolded binding
directly into the two folds at the
end of the scroll and draw it back
under the needle. As the binding
passes through the scroll the raw
edges are turned in.
●
The Binder
Page 35
Table of Contents | Previous Page | Next Page
To Next Page
Loading...
Need help?
General
