CDP-300 Installation Manual
Document Rev. 01.006 DOC0449 Page 10 of 31
Restricted Proprietary and Confidential Information
Section 5 — Configuration of the CDP-300
This section contains instructions on how to configure and set up the CDP-300 system.
Section 6 — Post Installation Tests
This section contains instructions for tests to be performed after installation, to confirm that the system has been
installed correctly.
Section 7 — Airworthiness Limitations
This section describes the installation and operational limitations of the CDP-300 system.
Section 8 — Maintenance and Continued Airworthiness
This section describes the steps required for the continued airworthiness of the CDP-300 system.
Section 9 — Firmware Updates
This section indicates the methods available to update the CDP-300 and where to find the required instructions.
Section 10 — CDP-300 Human Machine Interface
This section provides a brief description of the CDP-300 human machine interface components.
1.2.1 AUDIENCE
This manual is intended for qualified aircraft avionics technicians, referred to as installers. The context of the
manual assumes that the installer is familiar with the tools, materials, and techniques of wiring and metal work
required for installing radios, antennas, and related components into aircraft.
1.2.2 REFERENCES
Additional information about the components of the ISAT-200 system can be found in the ISAT-200 Installation
Manual (DOC0334), and the CDP-300 User's Guide (DOC0500).
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
Need help?
General