CDP-300 Installation Manual
Document Rev. 01.006 DOC0449 Page 23 of 31
Restricted Proprietary and Confidential Information
5 CONFIGURATION OF THE CDP-300
The main configuration required during installation is the brightness control configuration described below.
Additional configuration of the address book, quick dial numbers etc may be done by the user via the instructions
contained in the CDP-300 User’s Guide.
5.1 CDP-300 BRIGHTNESS CONFIGURATION
When used in the CDP/DVI mode, the CDP-300 brightness is slaved to the DVI-300 brightness control. (The DVI-
300 brightness is controlled via the aircraft dimmer bus). This mode is the default mode. Refer to the DVI-300
Installation Manual (DOC0456) for details on wiring the DVI-300 for dimmer bus brightness control.
Optionally, the brightness of the CDP/DVI can be controlled manually via the keypad or automatically via an
optical sensor which detects ambient light levels and sets the brightness appropriately. No wiring is required to
use the manual or optical sensor brightness control modes.
The user can choose one of the modes at any time via the menu interface. Refer to the CDP-300 User’s Guide
(DOC0500) for details about changing the mode of brightness control via the CDP-300 menu system.
In standalone mode, the CDP-300 can use the optical sensor or the dimmer bus may be wired to the CDP-300
and used to control brightness.
5.2 ISAT-200 CONFIGURATION
The CDP can also be used to configure the ISAT-200. Please refer to the ISAT-200 Installation Manual
(DOC0334) and CDP-300 User’s Guide (DOC0500) for additional information.
The CDP can be used to set the ISAT-200 DC Mic Bias on or off, set the Microphone input range, set the speaker
volume and select ring tones via the menu system.
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
Need help?
General