CDP-300 Installation Manual
Document Rev. 01.006 DOC0449 Page 17 of 31
Restricted Proprietary and Confidential Information
3 MECHANICAL INSTALLATION
3.1 GENERAL
This section contains procedures for the mechanical installation of the CDP-300. Included are unpacking
instructions, a table listing the weight of each component, and instructions for completing the physical installation
of the CDP-300.
3.2 INSTALLATION LIMITATIONS
The following installation regulations must be adhered to:
When installing the CDP-300 the installer must have a working knowledge of aircraft electronics installation, and
be a holder of either an FAA Repairman’s Certificate or a Transport Canada equivalent. All installations should
meet the requirements of FAA advisory circular AC43.13-1B.
3.3 MAIN INSTALLATION TASKS
The main tasks for this installation are listed below:
1. Unpack and inspect the system components. Check the contents of the installation kit against the
parts list on the Installation Kit Package and verify that all components are included and were not
damaged during shipping.
2. Product Mounting. Determine the approximate location of the CDP-300.
3. Install and secure the CDP-300.
4. Configure the CDP-300.
5. Test the CDP-300.
IMPORTANT NOTICE:
All system interconnect cables must be connected before power is applied to the system.
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
Need help?
General