CDP-300 Installation Manual
Document Rev. 01.006 DOC0449 Page 18 of 31
Restricted Proprietary and Confidential Information
3.4 CDP-300 COMPONENT WEIGHTS
The following table provides the weight for the CDP-300 system.
Table 6 – Component Weights
3.5 UNPACKING AND INSPECTING THE SYSTEM COMPONENTS
1. Check the items in the shipment against those listed on the shipping invoice to ensure that all items have
been received. If any items are missing, contact SKYTRAC Client Services.
2. Carefully remove each item from its individual packaging.
3. Inspect each item for damage that may have been incurred during shipping. In case it is necessary to
submit a damage claim, save the shipping container to help verify the claim.
4. After all items have been unpacked, it is suggested that you save the containers and packaging materials
in case it becomes necessary to reship an item.
5. Verify and record the serial number of the CDP-300. This information is required when contacting
SKYTRAC Systems to activate the satellite communications services.
3.5.1 PRODUCT MOUNTING
To operate as part of the CDP/DVI, the CDP-300 has to be mounted just above the DVI-300. If the CDP-300 is
mounted already, disconnect the connector for CDP-300 and remove the CDP-300 from the aircraft DZUS rails.
Place the CDP-300 over the DVI-300 and secure them together using CDP/DVI Mounting Brackets on both sides.
Connect the wiring harness to the rear of the CDP-300 and DVI-300. Be sure to install all connector mounting
hardware required. Mount the CDP-300 and DVI-300 to the aircraft DZUS rails using the DZUS fasteners on
them.
3.6 INSTALLATION MATERIALS
3.6.1 INSTALLATION KIT FOR THE CDP-300
The CDP-300 is installed using the CDP-300 Installation Kit (P/N: 106-300-01). The Installation Kit contains all the
components necessary to install the CDP-300. (Components from the ISAT-200 Installation Kit will also be
required.)
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
Need help?
General