SkyTrac Systems Ltd.
Document Rev. 01.020 DOC0334 Page 12 of 49
Restricted Proprietary and Confidential Information
1.3.6 ISAT-200 Supported Peripheral Devices
The ISAT-200 supports the following SkyTrac Systems control head product series:
DVI-250C and DVI-250A
CDP-250G and CDP-250C
Combination of the CDP-250 and DVI-250.
DVI-300C and DVI-300A
CDP-300G and CDP-300C
Combination of the CDP-300 and DVI-300.
It is recommended that a DVI-300 and CDP-300 be used in conjunction to make full use of the ISAT-
200 features. Additional peripherals may become available from time to time. Please go to
www.skytrac.ca or contact SkyTrac Client Services for more information.
Table 3– ISAT-200 Supported Peripherals
1
Note – Please refer to the latest version of the List of Approved Embedded Software (DOC0444)
for software version requirements for peripherals. This document can be obtained at
www.skytrac.ca or your program manager.
2
Note – The CDP-250 and DVI-250 require a special version of firmware to communicate with the
ISAT-200. Contact SkyTrac Client Services for more information.
DVI-250 NVIS Friendly, Push Button
DVI-250 NVIS Compatible, Push Button
All CDU-250s are comprised of a combination of the
above DVI-250 and CDP-250 models.
DVI-300 NVIS Friendly, Push Button
DVI-300 NVIS Compatible, Push Button
All CDU-300s are comprised of a combination of the
above DVI-300 and CDP-300 models.
The document reference is online, please check the correspondence between the online documentation and the printed version.