SkyTrac Systems Ltd.
Document Rev. 01.020 DOC0334 Page 34 of 49
Restricted Proprietary and Confidential Information
To set the ring tone volume go to System>Audio>Ring Vol. Select this item, toggle through the
choices “Go Back”, “1”, “2”, etc. Selecting any number will set the Ringer Volume to that level.
Start by selecting “4”. Go back and try to select a Ringtone. If the selected ringtone is not heard,
increase the ringtone volume and try again.
Only microphone bias, microphone input range and ring tone need to be selected by the installer,
the rest can be configured by the user. Audio configuration includes configuring the audio volume,
microphone gain, side tone volume, microphone bias, microphone input range and ring tone.
5.3 System Configuration
System configuration includes setting the registration number in the ITRAY-200, configuring position
reporting information, input operation, and other parameters. This configuration is performed within
SkyTrac’s Hardware Management section in SkyWeb. Please refer to SkyWeb documentation
available on the SkyTrac Website at www.skytrac.ca for more information on how to configure the
unit. Once the unit is configured, use SkyWeb as instructed to verify correct configuration.
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
Need help?
General
