-50-
No.PS※※-OMV1001
If the security code is forgotten
The following procedure can be used when the security code has been forgotten.
<Operation>
Press the button for 5 seconds or longer in measurement mode.
The current setting "UnL" or "LoC" is displayed.
Press the and buttons simultaneously for 5 seconds or longer.
Then, press the and buttons simultaneously for 5 seconds or longer.
: There will be no change to the display.
(at this time, if another operation is performed or no key operation is performed for 30 seconds, the
display will return to measurement mode).
Press the and buttons simultaneously for 5 seconds or longer. The display will change to "0000"
and the security code change mode will return.
(at this time, if another operation is performed or no key operation is performed for 30 seconds, the
display will return to measurement mode).
Refer to "How to change the security code" (page 48) and select a new security code.
The new security code will be displayed.
Check the security code is as required, and press the button for 1 second or longer.
The display will return to measurement mode.
At this time, if the or button is pressed, any security code changes will be lost, and the change of
security code procedure must be repeated.
To Next Page
Loading...
Need help?
General
