EasyManuals Logo
Home>Snap-On>Power Tool>CTR714A

Snap-On CTR714A User Manual

Snap-On CTR714A
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6
ZCTR714ACE Rev. E (08/19)
8. Do not operate the charger with damaged cord -
replace it immediately.
Cord replacement for CTC772A/CTCA772A/
CTCEU772A/CTCJ772A charger must be done
with an identical cord.
9. Do not operate charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way; take
it to a qualified service person.
10. Do not disassemble charger; take it to a qualified
service person when service or repair is required.
Incorrect reassembly may result in a risk of electric
shock or fire.
11. To reduce risk of electric shock, unplug charger before
attempting any maintenance or cleaning. Turning off
controls will not reduce this risk.
12. The appliance can be used by children aged from 16
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and understand the hazards involved.
13. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children
without supervision.
14. Do not recharge non-rechargeable batteries.
15. Never attempt to connect two chargers together.
16. Have your charger serviced by a qualified repair person
using only identical replacement parts. This will ensure
that the safety of the charger is maintained.
17. For the location of the nearest Snap-on repair center,
please call Snap-on customer service at 1-877-762-
7664.
18. To reduce risk of battery explosion, follow these
instructions and those marked on the battery.
19. Never smoke or allow an open spark or flame in the
vicinity of the battery or engine.
20. Never charge a frozen battery.
21. Do not operate charger in a closed-in area or restrict
ventilation in any way.
22. Do not use an extension cord unless absolutely
necessary. If an extension cord must be used, make
sure that the:
Pins on the plug of the extension cord are the
same number, size and shape of those of the plug
on the charger,
Extension cord is properly wired and in good
electrical condition, and
Wire size is large enough for AC ampere rating of
charger as follows
100-120 Volt
Charger
Cord Length (feet)
Wire Size (AWG)
25
50
100
18
18
18
220-240 Volt
Charger
Cord Length
(meters)
Wire Size (mm)
50
75
0.75
1.0
Recommended Extension Cord Length
SAVE THESE
INSTRUCTIONS
Functional Description
C
A
B
D
C
E
B
D
C
C
A
B
D
A
B
D
Figure 1: Cordless Ratchet
A – Drivebody - 1/4” square
B – Trigger
C – Selector Knob
D – Battery Pack
E – Drivebody - 1/4” hex bit
A
B
Figure 2: Battery Pack
A – Terminal
B – Latch Button

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Snap-On CTR714A and is the answer not in the manual?

Snap-On CTR714A Specifications

General IconGeneral
BrandSnap-On
ModelCTR714A
CategoryPower Tool
LanguageEnglish

Related product manuals