42
DM+ Advanced
DM+ Advanced improves digitally compressed
sound by restoring high frequencies lost in the
compression process.
This function works when the USB, SensMe™,
Pandora USB, Bluetooth Audio or Bluetooth
Pandora source is selected only.
1 During playback, press the multi-way
encoder.
2 Rotate the multi-way encoder until
“DM+ Advanced” appears, then press
it.
3 Push the multi-way encoder up/down
to select “on,” then press it.
4 Press (BACK).
The display returns to normal reception/play
mode.
Tip
Adjusted DM+ settings can be memorized separately
for USB (SensMe™, Pandora USB) and Bluetooth
Audio (Bluetooth Pandora) sources.
Using rear speakers as subwoofer
— Rear Bass Enhancer
Rear Bass Enhancer enhances the bass sound by
applying the low pass filter setting (page 39) to
the rear speakers. This function allows the rear
speakers to work as a subwoofer if one is not
connected.
1 During reception/playback, press the
multi-way encoder.
2 Rotate the multi-way encoder until
“Rear Bass Enhancer” appears, then
press it.
3 Push the multi-way encoder up/down
to select from “Level 1,” “Level 2” or
“Level 3,” then press it.
4 Press (BACK).
The display returns to normal reception/play
mode.
Compensating volume level —
Dynamic Loudness
“Dynamic Loudness” refers to compensating for
volume level and signal gain.
1 During reception/playback, press the
multi-way encoder.
2 Rotate the multi-way encoder until
“Dynamic Loudness” appears, then
press it.
3 Push the multi-way encoder up/down
to select “on,” then press it.
4 Press (BACK).
The display returns to normal reception/play
mode.
Adjusting setup items — MENU
1 Press and hold the multi-way encoder.
2 Rotate the multi-way encoder to select
the desired menu item, then press it.
3 Push the multi-way encoder up/down
to select the setting, then press it.
The setting is complete.
4 Press (BACK).
The setting is complete and the display
returns to normal reception/play mode.
The following items can be set (follow the page
reference for details):
Setup
Clock Adjust (page 8)
CT (Clock Time) (page 19)
Beep
Activates the beep sound: “on,” “off.”
RM (Rotary Commander)
Changes the operative direction of the rotary
commander controls: “NORM,” “REV.”
Auto Off
Shuts off automatically after a desired time
when the unit is turned off: “NO,” “30sec
(seconds),” “30min (minutes),” “60min
(minutes).”
DEV Inside Alert
Activates the Device Inside Alert function:
“off,” ”on.”
To Next Page
Need help?
General
Weight and Dimensions
