20
Step 2: Charging the battery pack
You can charge the “InfoLITHIUM”
battery pack (H series) (p. 115) after
attaching it to your camcorder.
b Notes
• Your camcorder operates only with
“InfoLITHIUM” battery pack (H series).
1 Turn the POWER switch in the
direction of the arrow to OFF
(CHG) (the default setting).
2 Align the terminals of the battery
pack and your camcorder (1),
then attach the battery pack in the
direction of the arrow until it
clicks (2).
3 Connect the AC Adaptor to the
DC IN jack of your camcorder.
Open the jack cover, and connect the
DC plug of the AC Adaptor.
Match the v mark on the DC plug with
the v mark on your camcorder.
4 Connect the power cord (mains
lead) to the AC Adaptor and the
wall outlet (wall socket).
The CHG (charge) lamp lights up and
charging starts.
5 The CHG (charge) lamp turns off
when the battery is fully charged.
Disconnect the AC Adaptor from
the DC IN jack.
POWER switch
DC IN jack
DC plug
AC Adaptor
Power cord (mains lead)
To the wall outlet
(wall socket)
Jack cover
CHG (charge) lamp
Battery
To Next Page
Loading...
Need help?
General