24
Step 3: Turning the power on, and setting the date and time (Continued)
3 Select the desired geographical
area with / , then touch
[NEXT].
4 Set [DST SET] or [SUMMERTIME],
then touch [NEXT].
5 Set [Y] (year) with / .
6 Select [M] with / , then set
the month with / .
7 Set [D] (day), hour and minute in
the same way, then touch [NEXT].
8 Make sure that the clock is
correctly set, then touch .
The clock starts.
You can set any year up to the year
2037.
For midnight, set it to 12:00 AM.
For midday, set it to 12:00 PM.
To turn off the power
Turn the POWER switch to OFF (CHG).
b Notes
• If you do not use your camcorder for about 3
months
, the built-in rechargeable battery gets
discharged and the date and time settings may
be cleared from the memory. In that case,
charge the built-in rechargeable battery and then
set the date and time again (p. 119).
• It takes a few seconds for your camcorder to be
ready to shoot after the power is turned on. You
cannot operate your camcorder during this time.
• The lens cover opens automatically when the
power is turned on. It closes when the playback
screen is selected, or the power is turned off.
• In the default setting, the power turns off
automatically if you leave your camcorder
unoperated for approximately 5 minutes, to save
battery power ([A.SHUT OFF], p. 84).
z Tips
• The date and time does not appear during
recording, but they are automatically recorded
on the media, and can be displayed during
playback ([DATA CODE], p. 79).
• See page 111 for information concerning
“World time difference.”
• If the buttons on the touch panel do not work
correctly, adjust the touch panel
([CALIBRATION], p. 118).
You can change the on-screen displays to
show messages in a specified language.
Touch (HOME)
t (SETTINGS)
t[CLOCK/ LANG]
t[ LANGUAGE SET], then select the
desired language.
Changing the language setting
To Next Page
Loading...
Need help?
General