HBD-TZ215/TZ715
13
2-9. MAIN BOARD
4 connector
(CN2101)
6 connector
(CN906)
7 connector
(CN904)
5 wire (flat type) (11 core)
(CN506)
1 two screws
(BV3 (3-CR))
8 four screws
(BV3 (3-CR))
9 heat sink block
0 holder (IC)
qa three screws
(BV3 (3-CR))
qa two screws
(BV3 (3-CR))
qs MAIN board
2 insulated plate
(POW)
3 Lift up two lead pins.
A
A
Note:
When the heat sink has been removed,
apply oil compound (G-747) to it.
$UUDQJLQJWKH86%ZLUH
Have the USB wire spread on the inside
of the claws of the chassis.
USB wire
USB wire
heat sink
heat sink
CN3000
CN509
CN906
red
black
Tie up with LP3002.
Tie up with LP501.
Draw the USB wire through CN3000.
Keep a distance of more than 6.5 mm
between the wire and CN901.
Keep the wire tied up from lying on
the heat sink and the POWER board.
Keep the wire tied up from lying on
the heat sink and the POWER board.
POWER board
CN901
To Next Page
Loading...
Need help?
General
