HCD-SBT100/SBT100B/SBT300W/SBT300WB
14
2-9. NET BOARD BLOCK (HCD-SBT300W/SBT300WB)
2-10. WiFi MODULE (WIFI1), NET BOARD (HCD-SBT300W/SBT300WB)
A
A
4 screw
(BVTP3 u 8)
3 two screws
(BVTT3 u 6)
2 tape
(sub material)
1 antenna connector
(CON2)
5 NET board block
tape
(sub material)
:LUHVHWWLQJ
Note:
Arrange the antenna wire so as not to overlap
with the screw hole of panel (rear).
antenna wire
NET board
2 connector
(CN5002)
4 cushion
(poron T5.5)
5 NET board
3 WiFi module (WIFI1)
1 two screws
(BVTT3 u 6)
Note 1: When the complete NET board is replaced, refer to “CHECK-
ING METHOD OF NETWORK CONNECTION” on page 5.
Note 2: When the WiFi module (Ref. No. WIFI1) is replaced, refer to
“PROCESSING OF REPLACING THE WiFi MODULE (Ref.
No. WIFI1)”, “NOTE OF REPLACING THE WiFi MODULE
(Ref. No. WIFI1)” and “CHECKING METHOD OF NET-
WORK CONNECTION” on page 5.
To Next Page
Loading...
Need help?
General
