19
IP stream status
Displayed only when HKCU-SFP50 is installed.
Displays the stream status during IP transmission.
OUT: Outgoing IP stream
IN: Incoming IP stream
-----: No incoming/outgoing stream
Warning display
Displays any warning that occurs.
Settings Using the Menu
of the Unit
The CCU system and peripheral settings can be checked and
modified using a video monitor connected to the
CHARACTER, SDI OUT 3, or SDI OUT 4 connector.
To use the SDI OUT 3 or SDI OUT 4 connector, set SYSTEM
CONFIG t <OUTPUT FORMAT1> t SDI-OUT3 or
SDI-OUT4 t MONITOR in the setup menu to M.
Changing Menu Item Settings
The menu screen is controlled using the knob and levers in the
MENU control block on the front panel. Setting the CANCEL/
ENTER lever to the ENTER position and pressing the
CONTROL knob perform the same function.
To display a menu page
Set the DISP/MENU lever to the MENU position.
When first powered on, the CCU MENU page is displayed.
When <OUTPUT FORMAT1> t SDI-OUT4 t MONITOR is
set to C (characters are not added), you can hold the DISP/
MENU lever in the MENU position for 3 seconds to force
display of the CCU MENU.
To display the CCU MENU page
In menu display mode, turn the CONTROL knob to move the
pointer (,) to TOP in the upper right corner of the menu
page, then press the CONTROL knob. The CCU MENU
showing the menu configuration is displayed.
*IP Stream* 10/11
OUT VIDEO1 IN RETURN1
VIDEO2 RETURN2
VIDEO3 RETURN3
----- -----
AUDIO PGM
HD TRUNK AUDIO
INTERCOM INTERCOM
META1
META2
META3
-----
*Alarm* 11/11
CCU:PS FAN STOP
CCU:GENLOCK ERROR
Note
DISP/MENU lever and indicator
CANCEL/ENTER lever
CONTROL knob
** CCU MENU **
c
SYSTEM CONFIG
VIDEO/MONITOR
AUDIO/INTERCOM
MAINTENANCE
FILE
NETWORK
DIAGNOSIS
To Next Page
Loading...
Need help?
General
