72
MAINTENANCE Menu
MAINTENANCE
Page name
Page No.
Item Set value Description
<TRUNK/PROMPTER>
M01
TRUNK LINE
CHANNEL MODE 2CH(MAX 75Kbps)
,
1CH(MAX 150Kbps)
Sets the number of channels to be used.
INTERFACE 232C
, 422A Sets the communication line mode.
PROMPTER CH 2CH
, 1CH Sets the number of prompter lines.
The number of lines will vary depending on the
number of prompter lines of the connected camera.
<TRUNK/PROMPTER2>
M02
NETWORK TRUNK OFF
, NETWORK,
NETWORK+VIDEO
Sets the mode for the network trunk.
OFF: NETWORK TRUNK is not used.
NETWORK: Network Trunk is used (maximum
1Gbps)
NETWORK+VIDEO: Network trunk is used at the
same time as HD Trunk/HD Prompter (maximum
100 Mbps)
When <CAMERA I/F> t FIBER TRANSMIT RATE
is set to ULTRA, this is set to NETWORK+VIDEO
(fixed).
DATA RATE 100Mbps, 1Gbps Displays the data transfer rate.
When <CAMERA I/F> t FIBER TRANSMIT RATE
is set to ULTRA, this item can be set.
CAMERA ENABLE, DISABLE Displays whether the camera is enabled/disabled
(Display only).
HD/UHD TRUNK ENABLE, DISABLE Displays whether HD TRUNK is enabled/disabled
(Display only).
DATA RATE 1.5G
, 12G Displays the HD TRUNK data rate.
HD PROMPTER ENABLE, DISABLE Displays whether HD PROMPTER is enabled/
disabled (Display only).
Fixed to DISABLE when using SDI-RET on
HDCU5000/5500.
FRAME SYNC OFF, ON, (ON) Turns the frame synchronizer function ON/OFF.
SOURCE SDI-I/O4
, IP-RET3 Sets the HD prompter signal source.
IP-RET3 can be selected only when the
HKCU-SFP50 ST 2110 Interface Kit is installed.
UHD PROMPTER ENABLE, DISABLE Displays whether UHD prompter is enabled/disabled
(Display only).
DATA RATE 1.5G
, 3G, 6G, 12G Sets the UHD prompter data rate.
FRAME SYNC OFF
, ON, (ON) Turns the frame synchronizer function ON/OFF.
SOURCE UHD-SDI D
Sets the UHD prompter signal source.
To Next Page
Loading...
Need help?
General
