16
Usage Notes
Do not block the vents
When installing, ensure the following space around the
periphery of the unit, taking ventilation and servicing into
consideration.
– Rear side: 10 cm (4 in.) or more
– Left/Right sides: 10 cm (4 in.) or more
– Top side: 10 cm (4 in.) or more
Do not subject the unit to severe shocks
The internal mechanism may be damaged or the body
warped.
Do not cover the unit while operating
Doing so will cause temperatures to rise inside the unit,
possibly resulting in failure.
After use
Press the 1 (on/standby) switch to enter standby mode. If
you do not intend to use the unit for an extended period,
set the main power switch to the a (off) position after
entering standby mode, and then disconnect the power
cord.
Shipping
• Remove the BD/DVD disc before transporting the unit.
• If sending the unit by truck, ship, air or other
transportation service, pack it in the shipping carton of
the unit.
Care of the unit
If the casing, or panel becomes dirty, wipe them gently
with a soft, dry cloth.
For stubborn dirt, use a cloth wet with mild liquid
detergent to wipe the unit, and then wipe it with a dry
cloth. Using alcohol, thinner, benzine, insecticides, or
other volatile substances may damage the surface of the
unit or remove the finish.
Use isopropyl alcohol with a concentration of 50% to
70% (v/v) or ethanol with a concentration of 76.9% to
81.4% (v/v) to clean the surface of the unit.
In the event of operating problems
If you should experience problems with the unit, contact
your Sony dealer.
To Next Page
Loading...
Need help?
General
