Sony HXR-NX70C - Chassis Section-1 Exploded View and Disassembly

HXR-NX70C/NX70E/NX70J/NX70N/NX70P/NX70U
2-5
2-1-3. CHASSIS SECTION-1
1. Remove to numerical order (1 to 5) in the left figure.
DISASSEMBLY
1 #14 X 2
Screw
Left View
#14
#2: M1.7 X 4.0
(Black)
2-635-562-31
4.0
1.7
#14: M1.7 X 2.5
(Silver)
2-599-475-11
2.5
1.7
4 Disconnect the flexible board
→
#14 X 2
→
Bring up EVF (4)
→
#2 X 4
4
Left ViewBottom View
Right View
Back View
#14
Disconnect
flexible board
#14
#2
Note
Note 1: Refer to “Assembly-1: Installation Cautions of the DC Jack
Harness.”.
Note 1:
“Assembly-1: Installation Cautions of the DC Jack Harness.”
を参照してください。
#14
#14
#14
#2
#14
#14
#14
#14
2 104
1 103
3 102
5 101
(Note 2)
4 Rear Section
(See page 2-15)
(Note 1, 2)
Chassis Section-2
(See page 2-6)
2 #14 X 1
Left View
#14
3 #14 X 3
Left View Right ViewTop View
#14
#14
#14
Ref. No. Part No. Description
Ref. No. Part No. Description
101 4-282-252-01 PACKING, CABINET (RE) (Note 2)
102 4-282-362-01 HEAT SINK, BT
103 4-282-272-01 GUARD, L FLEXIBLE
104 4-282-275-01 CLIP, DC HARNESS
#2 2-635-562-31 SCREW (M1.7)
#14 2-599-475-11 SCREW (M1.7)
図中で取り外しているねじは、下記の
トルクで締めつけてください。
(0.13±0.02N・m (1.3±0.2kgf・cm))
Tighten all screws that are removed in
the figure below to the following torque.
(0.13±0.02N・m (1.3±0.2kgf・cm))
緑色の部品はパッキンです。
Green parts are packings.
Note 2: Refer to “Assembly-12:
Assembly Cautions of the Rear Section
and PACKING, CABINET (RE).”.
Note 2:
“Assembly-12: Assembly Cautions of the Rear Section and
PACKING, CABINET (RE).” を参照してください。