Help Guide
Interchangeable Lens Digital Camera
ILME-FX3 Ver.2 or later
Zebra Display
Sets a zebra pattern, which appears over part of an image if the brightness level of that part meets the IRE level that you
have set. Use this zebra pattern as a guide to adjust the brightness.
Menu item details
Zebra Display:
Sets whether to display the zebra pattern. ([Off] / [On])
Zebra Level:
Adjusts the brightness level of the zebra pattern. ([70] / [75] / [80] / [85] / [90]/ [95] / [100] / [100+])
Hint
[Zebra Display Select] is assigned to the left side of the control wheel in the default settings.
You can register values to check the correct exposure or overexposure as well as the brightness level for [
Zebra Level]. The
settings for correct exposure confirmation and overexposure confirmation are registered to [Custom 1] and [Custom 2]
respectively in the default settings.
To check the correct exposure, set a standard value and the range for the brightness level. The zebra pattern will appear on
areas that fall within the range you set.
To check the overexposure, set a minimum value for the brightness level. The zebra pattern will appear over areas with a
brightness level equal to or higher than the value you set.
Note
The zebra pattern is not displayed on devices connected via HDMI.
5-043-414-12(1) Copyright 2022 Sony Corporation
MENU →
(Exposure/Color) → [Zebra Display] → Select a menu item and set the desired parameter.
1
To Next Page
Loading...
Need help?
General
