Help Guide
Interchangeable Lens Digital Camera
ILME-FX3 Ver.2 or later
Access Point Set.
You can register your access point manually. Before starting the procedure, check the SSID name of the access point,
security system, and password. The password may be preset in some devices. For details, see the access point
operating instructions, or consult the access point administrator.
Other setting items
Depending on the status or the setting method of your access point, you may want to set more items.
For an unregistered access point, select the [Detail] button on the password entry screen.
MENU →
(Network) → [Wi-Fi] → [Access Point Set.].
1
Select the access point you want to register.
When the desired access point is displayed on the screen: Select the desired access point.
When the desired access point is not displayed on the screen: Select [Manual Setting] and set the access
point.
If you select [Manual Registration], input the SSID name of the access point, then select the security system.
If you select [WPS PIN], you can register the access point by entering the PIN code displayed on the camera
into the connected device.
2
Input the password, and select [OK].
Access points without (Lock mark) do not require a password.
Note that unmasking your password risks revealing your password to a third party. Make sure that no one is
around before unmasking.
3
Select [OK].
4
To Next Page
Loading...
Need help?
General
