Help Guide
Interchangeable Lens Digital Camera
ILME-FX3 Ver.2 or later
Self-timer(Single)
Shoots an image using the self-timer after a designated number of seconds have elapsed since the shutter button was
pressed. Use the 5-second/10-second self-timer when you are going to be in the picture, and use the 2-second self-timer
to reduce camera-shake caused by pressing the shutter button.
Menu item details
The mode determines the number of seconds until a picture is taken after the shutter button is pressed.
Self-timer(Single): 10 sec
Self-timer(Single): 5 sec
Self-timer(Single): 2 sec
Hint
Press the shutter button again to stop the count of the self-timer.
Select MENU →
(Shooting) → [Drive Mode] → [Drive Mode] → [Single Shooting] to cancel the self-timer.
Set [Audio signals] to [Off] to turn off the beeping sound during the self-timer countdown.
To use the self-timer in bracket mode, select bracket mode under drive mode, then select MENU →
(Shooting) → [Drive
Mode] → [Bracket Settings] → [Selftimer during Bracket].
Related Topic
Audio signals
5-043-414-12(1) Copyright 2022 Sony Corporation
MENU →
(Shooting) → [Drive Mode] → [Drive Mode] → [Self-timer(Single)].
1
Select the desired mode using the right/left side of the control wheel.
2
Adjust the focus and shoot the image.
The self-timer lamp flashes, a beep sounds, and a picture is taken after the designated number of seconds have
elapsed.
3
To Next Page
Loading...
Need help?
General
